Unbranded/Generic

7.5 HP 1 Phase Magnetic Starter NEMA 1 208-240V 32 - 48 Amp P40TPB

Low stock: 1 available
SKU: MSP40TPB
$139.95
60-day returns No-hassle policy
US-based support Mon–Fri 8:30–4:30 CT
Same-day shipping Order by 1:30 PM CT
45+ years expertise Compressor specialists

Brand new 7.5 horsepower single phase 220-240 volt magnetic starter with a manual on & off push button control mounted on the front of the steel starter housing. This is a great quality starter with a built in overload which is adjustable from 32-48 amps. Also has a manual reset button that can be switched to auto reset. The steel housing has four 3/4"punch out holes for incoming and outgoing wires. Also included are three rubber surround grommets for the 3/4" holes to protect the wires if needed. Starter comes with basic wiring instructions.


PROFESSIONAL INSTALLATION IS REQUIRED

Specifications:

-Starter Housing Size:
9" Tall, 5-1/2" Wide, 5-1/2" Deep
-Starter Rating:
7.5HP, 220-240 Volt, Single Phase (Works w/ 208 Volt)
-Amp Rating: 32-48 Amps / Adjustable
-Equipped With Push Button "On/Off"

This starter is designed for bandsaws, table saws, augers and other equipment that needs a starter with an on and off button. This starter is not designed to be used on a air compressor because it wont wire in with the pressure switch due to the on and off button. If you are wanting a starter for a air compressor use our version without the on and off button.

Due to this being an electrical item that can be installed incorrectly there is no warranty on this item after installation.

Overview

Brand Shihlin Electric
Horsepower Maximum motor horsepower this starter is rated to control at the listed voltage and phase. 7.5 HP
Phase Single Phase
Voltage 208-240 V
Frequency 60 Hz
Overload adjustment range The overload relay’s adjustable trip-current band. Set the dial to roughly 115% of the motor’s full-load amps. 32.0–48.0 A
Enclosure NEMA 1 = general-purpose indoor. NEMA 4X = washdown / outdoor, dust- and corrosion-resistant. NEMA 1
Country of origin Where this starter is manufactured, per the manufacturer / supplier documentation. China
Catalog / part number P40TPB

Contactor & Control

Control scheme The pilot devices wired in: e.g. Reset only, Start/Stop + Reset, or Hand-Off-Auto (HOA). On/Off buttons

Overload Protection

Reset mode Manual reset requires pressing the button after a trip; automatic re-closes on cooldown. Manual (switchable to automatic)

Enclosure & Physical

Enclosure material Steel
Dimensions (H × W × D) Approximate enclosure size from the manufacturer catalog. 9.0″ H × 5.5″ W × 5.5″ D

Ratings & Compliance

Application notes Steel-enclosure starter with front On/Off push buttons (for saws, augers, etc.). Not for air-compressor use — the On/Off buttons conflict with a pressure switch.