PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
1/2" MNPT X 1/2" Compression Thread Air Compressor In Tank Check Valve
One new 1/2" compression x 1/2" male NPT in tank compressed air check valve. This style of check valve is usually screwed directly into the air tank, then the main line coming off the compressor pump is connected to it. This valve prevents backflow or tank pressure from getting back into the air compressor pump once the compressor has been shut off. This valve has a 1/8" female NPT port in the side which usually goes to an unloader valve on your pressure switch or compressor pump. If your application does not use an unloader line, this port can just be plugged.
Specifications:
Total Length: 2-3/4"
Tank Threads: 1/2" Male NPT (measure about 3/4" in diameter)
Compressor Line Input Threads: 1/2" Compression (measure about 11/16" in diameter)
Unloader Line Input: 1/8" Female NPT (measures about 10/32" in diameter)
Installation Wrench Size: 7/8"