PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
1/4" male NPT compressed air tank cable-style pull drain. This drain is designed to replace existing twist-style petcock-style moisture-release tank drains. The drain valve screws into the bottom of your tank where the petcock drain was and the cable connected to the drain valve mounts up on the base plate of the air tank or somewhere that it is easy to pull. With this style of drain, you don't have to get underneath the tank to drain it, you just pull the cable and it releases the moisture. This valve is made in the USA and is solid brass. The wire cables connected to them have a poly coating over them. The valve drains when the connected cable pulls the pin in the center of the valve to the side.
Specifications:
• Drain connection: 1/4" male NPT (measures about 1/2' in diameter)
• Max pressure: 250 PSI
• Cable length: 60"
• You will receive 1 drain valve with this purchase