PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
7.5 HP Single Phase Magnetic Starter
Brand new 7.5 horsepower single phase 220-240 volt magnetic starter with a steel housing. This is a great quality starter with a built in overload which is adjustable from 32-48 amps. Also has a manual reset button that can be switched to auto reset. The steel housing has four 3/4"punch out holes for incoming and outgoing wires. Also included are three rubber surround gromets for the 3/4" holes to protect the wires if needed. Starter comes with wiring instructions.
PROFESSIONAL INSTALLATION IS REQUIRED
Specifications:
• Dimensions H x W x D: 9" x 5-1/2" x 5-1/2"
• 7.5 HP
• 220-240 Volt
• Single Phase
• Amp Rating: 32-48 Amps / Adjustable
If you currently have a 7.5 HP air compressor and the contacts on your pressure switch keep burning up, a starter is what is needed to fix the problem.
If you are using this starter on an air compressor, you will also need a pressure switch to control the starter. In this application the pressure switch controls the On and Off of the starter according to the pressure setting of the pressure switch.
Due to this being an electrical item that can be installed incorrectly there is no warranty on this item after installation.