PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
1/4" x 1/8" Compression x Male NPT Adapter Pipe Fitting Tube Connector Ferrule
1/4" x 1/8" Compression x Male NPT Adapter
This is a 1/4" Compression x 1/8" Male NPT fitting and is made of solid brass. This fitting is used to connect 1/4" outside diameter tubing to threaded pipe conforming to the National Pipe Thread (NPT) standard. This coupling is for a fixed connection between tubing and pipe made of copper, aluminum, and thermoplastic.
A single ferrule compression fitting connects to tubing on one end for a leak-resistant seal, and a male NPT connector on the other end connects to a threaded pipe. Single ferrule compression fittings have fewer possible leak paths than twin ferrule fittings.
Specifications:
• Use with Copper, Aluminum, and Thermoplastic Tubing
• Not Recommended for Steel Tubing
• Max Pressure: 300 PSI
• Vibration Resistance: Fair
• Temperature Range: -65°F to 250°F
• Tolerance: +/- .02 on All Dimensions
• Meets Specifications and Standards of ASA, ASME, and SAE
This listing is for one (1) compression adapter.