PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
Brand new 15 horsepower three-phase 460/480 volt magnetic starter control switch with steel housing. This is a great quality starter with a built-in overload that is adjustable from amps. It also has a manual reset button that can be switched to auto-reset. The steel housing has four 3/4" punch-out holes for incoming and outgoing wires. Also included are four rubber surround grommets for the 3/4" holes to protect the wires if needed. This starter does come with basic wiring instructions.
PROFESSIONAL INSTALLATION IS REQUIRED
Specifications:
Dimensions: 9" Tall, 5 1/2" Wide, 51/2" Deep
Starter Rating: 15 HP, 460/480 Volt, 3 Phase
Amp Rating: 17-21 Amps / Adjustable
If you are using this starter on an air compressor, you will also need a pressure switch to control the starter. In this application, the pressure switch controls the On and Off of the starter according to the pressure setting of the pressure switch.
Due to this being an electrical item that can be installed incorrectly there is no warranty on this item after installation.