3/8" FNPT x 1/2" MNPT 95-125 PSI Piloted Discharge Check Valve / Unloader Combo
This listing is for one new 95-125 PSI piloted discharge check valve/unloader valve combo. This check valve combo is made by Conrader in the U.S.A., It is an NS series valve. This valve is usually used on compressors that pump less than 20 CFM and can be used on gas or electric compressors. This valve is equipped with an in-line check valve and attached to the side is a built-in piloted unloader valve set 95-125 PSI. This valve also has a muffler in the exhaust air port to quiet down the unloaded exhaust air that is released once the compressor reaches 125 PSI. On the side of the valve, it has a 1/8" female NPT port, to control the throttle on a gas engine and/or unloader valves on some pumps.
For more information see specs below.
• Unloader ON/OFF: 95-125 PSI
• Air Inlet: 3/8" Female NPT Thread (measures about 5/8" in diameter)
• Air Outlet: 1/2" Male NPT (measures about 3/4" in diameter)
• 1/8" Side Unloader Port (measures about 3/8" in diameter)
• Exhaust Port with Muffler
This valve is set at 95-125 PSI once your compressor pumps up to 125 PSI the unloader valve will kick in and your compressor will pump air through the muffler out to the atmosphere until your air tank pressure gets down to 95 PSI Then the unloader will shut and your compressor will pump back up.