PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
Condor MDR3/11 120-150 PSI 4 Port Pressure Switch Adjustable Overload 1/4" FNPT
Condor 31QC3EMX Four Port Pressure Switch 120-150 PSI w/ Unloader Port
Brand new 120-150 PSI air compressor pressure switch or also known as a pressure control valve. This switch has four ports on the bottom for air inlet hookups, which are all 1/4" female NPT and also has a 1/4" compression unloader valve that comes out the bottom of the switch with a 90-degree elbow and swivels. This switch works with 110/220 volt motors and can handle 30 full load amps at 220 volts. This switch also has an adjustable overload from 22 amps up to 30 amps.
Specifications:
• Factory Set Pressure Range: 120-150 PSI
• Adjustable Pressure Setting up to 20 PSI +/-
• Adjustable Overload: 22-30 Amps
• Max Switching Capacity: 30 Full Load Amps at 220 Volts
• Switch Works with 110/220 Volts
• 1/4" Female NPT Connections
• 1/4" Compression Unloader Valve
• Four Port
• Single or Three Phase
• NEMA 1 Enclosure
• Steel Flange
This listing is for one (1) Condor 31QC3EMX pressure switch.