PURCHASED A PUMA PK-65 PUMP. AFTER VIEWING THE PUMA WEBSITE AND THE CS WEBSITE IT WAS DETERMINED THERE WAS A MAX RPM DISCREPANCY. I HAD ALREADY ORDERED A 3.5 INCH PULLEY, BUT IT WAS DETERMINED AFTER DISCUSSION, I NEEDED A 4 INCH. COMPRESSOR SOURCE ACKNOWLEDGED THE ERROR AND I WAS ABLE TO SEND THE WRONG ADVISED PULLEY BACK FREE OF CHARGE AND GET THE CORRECT ONE. SHIPPING WAS VERY VERY FAST AND APPRECIATIVE. THESE FOLKS ARE GREAT, BUT,I CANT SAY THE SAME FOR THE PUMP. THE WEBSITE SAYS 14-22 SCFM BUT I ONLY GOT 13.8 AT 90PSI USING THE WEBSITE CALCULATOR. I WAS HOPING FOR A BIT MORE, BUT I WILL DEAL WITH IT. I WISH I HAD WENT A DIFFERENT ROUTE ON THAT. BUT, WITH THAT BEING SAID, THE CUSTOMER SERVICE WAS SECOND TO NONE AND I WOULD GLADLY BUY FROM THESE FOLKS AGAIN.
Milton M Style Coupler 3/8" Female NPT Brass Body Buna-N Seal 300 PSI Max 718
Milton M Style Coupler 3/8" Female NPT
The Milton 3/8" FNPT M-Style coupler is great for any workshop or garage. Milton's M-Style KWIK-CHANGE couplers are made of brass. This coupler will interchange with all manufacturers who comply with the dimensional requirements of military specification MIL-C-4109. M-Style couplers and plugs offer up to 300 PSI and have an airflow of 40 SCFM and are made right here in the U.S.A. Please see below for more features and specifications.
Features and Specifications
•Maximum Inlet Pressure of 300 Pounds Per Square Inch
• Air Flow of 40 Standard Cubic Feet Per Minute
• Maximum temperature of 250 degrees Fahrenheit
• 3/8" National Pipe Thread (NPT)
• Comes With One 3/8" FNPT Coupler
• Made in USA
This Listing Is For ONE Milton M-Style Coupler